Choosing The Input Signal - Pioneer VSX-D814 Operating Instructions Manual

Listening to your system
• If you switch on Midnight listening, Loud-
ness, or the Tone controls when DIRECT is
selected, the receiver automatically
switches to STEREO.

Choosing the input signal

• Default setting: AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
ADVANCED
STATION TUNING
STANDARD SURROUND
LISTENING MODE
TUNER EDIT CLASS BAND MPX INPUT ATT FL DIMMER
MULTI JOG
• Press SIGNAL SELECT on the front
panel to select the input signal corre-
sponding to the source component.
Each press cycles through the options as
follows:
• AUTO – This automatically switches to
DIGITAL if a digital source is detected,
otherwise it remains on ANALOG.
• DVD 5.1ch – Selects the multichannel
inputs (only appears when DVD/LD is
selected).
• ANALOG – Selects the analog inputs.
• DIGITAL – Selects the digital input.
When set to DIGITAL or AUTO, 2 DIGITAL
lights when a Dolby Digital signal is input,
and DTS lights when a DTS signal is input.
• This receiver can only play back Dolby
Digital, PCM (32kHz–96 kHz) and DTS
digital signal formats (including DTS
96kHz/24 bit). With other digital signal
formats, set to ANALOG.
MULTI JOG
STEREO/ SIGNAL MIDNIGHT/ SB CH
TONE
DIRECT SELECT LOUDNESS SPEAKERS MODE QUICK SETUP
VIDEO INPUT
MCACC
SETUP MIC DIGITAL IN S-VIDEO VIDEO L AUDIO R
• You may get digital noise when a LD or CD
player compatible with DTS is playing an
analog signal. To prevent noise, make the
proper digital connections (page 17) and
set the signal input to DIGITAL.
• Some DVD players don't output DTS
signals. For more details, refer to the
instruction manual supplied with your
DVD player.
06
37
En