Selecting The Multi-Channel Analog; Inputs; Using The Sleep Timer - Pioneer VSX-D814 Operating Instructions Manual

Listening to your system
Selecting the multi-channel
analog inputs
If you have connected a decoder or a DVD
player with multi-channel analog outputs to
this receiver (page 18), you must select the
analog multi-channel inputs for surround
sound playback.
ADVANCED
STATION TUNING
STANDARD SURROUND
LISTENING MODE
TUNER EDIT BAND MPX INPUT ATT FL DIMMER
CLASS
MULTI JOG
1 Press DVD (DVD/LD on the front
panel).
2 Press SIGNAL SELECT on the front
panel repeatedly to select DVD 5.1ch.
To cancel playback from the multi-channel
inputs, use the SIGNAL SELECT button to
select a different input signal.
• When playback from the multi-channel
inputs is selected, you can't use the
INPUT ATT, TONE, and MIDNIGHT/
LOUDNESS buttons, as well as the STAN-
DARD, ADVANCED SURROUND, and
STEREO/DIRECT sound modes.
• When playback from the multi-channel
inputs is selected, only the volume and
channel levels can be set.
MULTI JOG
STEREO/ SIGNAL MIDNIGHT/ SB CH
DIRECT SELECT LOUDNESS SPEAKERS MODE TONE QUICK SETUP
VIDEO INPUT
MCACC
SETUP MIC DIGITAL IN S-VIDEO VIDEO L AUDIO R

Using the sleep timer

The sleep timer switches the receiver into
standby after a specified amount of time so
you can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
MPX CH RETURN
AUDIO SUBTITLE
RECEIVER CONTROL
STANDRAD ADV. SURR
MIDNIGHT/
LOUDNESS TEST TONE
SHIFT
CH SELECT
RECEIVER
• Press SLEEP repeatedly to set the sleep
time.
90 min
Off
• You can check the remaining sleep time
at any time by pressing SLEEP once.
Pressing repeatedly will cycle through the
sleep options again.
• You can also switch off the sleep timer
simply by switching off the receiver.
HDD DVD
CH CH
STEREO SLEEP
LEVEL EFFECT
60 min
30 min
06
41
En