Using The Quick Setup - Pioneer VSX-D712-S Operating Instructions Manual

02 5 minute guide

Using the Quick Setup

You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
Note that with the VSX-D912 you don't have to
make these settings if you use the automatic
MCACC setup instead (in this case, go
straight to the Quick surround sound setup on
page 14).
If you want to make more specific settings,
refer to Choosing your receiver setup on
page 43.
Use the front panel controls for the steps
below.
ADVANCED STEREO/ SIGNAL MIDNIGHT/
SURROUND DIRECT SELECT LOUDNESS SPEAKERS
ENING MODE
L DIMMER
DIGITAL IN S-VIDEO
1 If the receiver is off, press
STANDBY/ON to turn the power on.
The STANDBY indicator goes out.
2 Press QUICK SETUP.
SW DET flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES or SW NO confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
12
En
ENTER
MASTER VOLUME
MONITOR TONE QUICK SETUP
DOWN
MULTI JOG
VIDEO INPUT
VIDEO L AUDIO R
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
7.1ch*
* VSX-D812/D912 only
If a subwoofer wasn't detected in step 2, you
can cycle between the following choices:
7.0ch*
* VSX-D812/D912 only
• Check the table below to find the speaker
MULTI JOG
setup that corresponds with your system.
UP
R
* VSX-D812/D912 only
2.1ch 3.1ch
6.1ch 5.1ch
2.0ch 3.0ch
6.0ch 5.0ch
4.1ch
4.0ch