Erasing One Of The Remote Control; Button Settings - Pioneer VSX-D814 Operating Instructions Manual

Controlling the rest of your system
Certain buttons represent operations that
cannot be learned from other remote
controls. The buttons available are shown
below:
INPUT
RECEIVER
SELECT
DVD/LD TV/SAT
MULTI CONTROL
CD CD-R/TAPE
INPUT ATT FL DIMMER
+10
D.ACCESS
TOP MENU
TUNE
ST
DTV MENU
ENTER
T.EDIT
TUNE
GUIDE
TV CONTROL
INPUT
TV VOL
SELECT
DTV ON/OFF REC
TUNER
DISPLAY
MPX CH RETURN
AUDIO SUBTITLE
RECEIVER CONTROL
STANDRAD ADV. SURR
MIDNIGHT/
LOUDNESS TEST TONE
SHIFT
CH SELECT
RECEIVER
6 To program additional signals for the
current component repeat steps 4 and 5.
To program signals for another component,
exit and repeat steps 1 through 5.
7 Press the RECEIVER button to exit and
store the operation(s).
SOURCE
DVR/VCR TV CONT
TUNER RECEIVER
SR
DISC
ENTER
SETUP
CLASS
MENU
ST
MCACC
SETUP
BAND
RETURN
TV CH VOL
DTV INFO MUTE
REC STOP
HDD DVD
CH CH
STEREO SLEEP
LEVEL EFFECT
• Some commands from other remote
controls cannot be learned, but in most
cases the remotes just need to be moved
closer together or farther apart.
• If the remote LCD shows FULL, it means
the memory is full. See Erasing one of the
remote control button settings below to
erase a programmed button you're not
using to free up more memory.
• TV CONTROL buttons (TV ,TV VOL +/–,
TV CH +/– and INPUT SELECT) can only
be learned after selecting TV/SAT or TV
CONT.
Erasing one of the remote
control button settings
VSX-D914 model only
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1 While pressing the RECEIVER button,
press and hold the 1 button.
The remote LCD display shows SETUP.
2 Press the the MULTI CONTROL button
corresponding to the button setting to be
erased.
The LCD on the remote displays the compo-
nent.
3 Use and to select ERASE then
press ENTER.
The LCD display flashes PRES KEY.
4 Press and hold the button to be erased
for two seconds.
The LCD display shows OK to confirm the
button has been erased. NO CODE is
displayed if there is nothing to erase.
10
59
En