Advertisement
August 2017
1.0
Location and orientation
The pipe clamp sensor should be mounted on the outside section of the pipe
where the process medium is in contact of the inside of the pipe wall. Ensure
that the pipe surface is clean of debris. The pipe clamp sensor should be
mounted in a secure position to ensure there is no rotational movement after
installation. To ensure ingress protection, the nut of the Rosemount 0085 Pipe
Clamp sensor can be tightened to compress the O-ring to form a seal. The nut
can be accessed and tightened by removing the sensor and the nipple union of
the extension. Refer to
each part.
1.1
Horizontal orientation
Though the Rosemount 0085 Pipe Clamp sensor can be mounted in any
orientation for full pipe flow applications, the best practice is to mount the pipe
clamp sensor on the upper half of the pipe. Refer to
information.
Figure 2. Horizontal Orientation
1.2
Vertical orientation
The pipe clamp sensor can be installed in any position around the circumference
of the pipe.
"Location and orientation" on page 3
Full pipe flow
360°
Quick Start Guide
for the location of
Figure 2
for more
Partial pipe flow
Recommended
Zone
3
Advertisement
