Table of Contents
Advertisement
Accessories
Attach Optional Rubber Feet
1.
Place the rubber foot between the spikes. Check the marking on
the foot for the correct orientation. The 'OUTSIDE' marking must
be turned away from the centre of the tripod.
2.
Bend the rubber strap
1
lever in the tripod recess.
3.
2
Lift the lever
upwards towards the tripod until it locks in place.
2
14
and engage the bottom edge of the
1
Maintenance
Cleaning
Video tutorials are available. Please visit
www.vinten.com/flowtech
details.
CAUTION! Do not use solvent or oil based cleaners,
!
abrasives or wire brushes to remove accumulations of
dirt as these will damage the protective surfaces. Use
clean water only.
During normal use the only cleaning required is a periodic
wipe-down with a lint-free cloth. Any dirt that accumulates during
storage or periods of non-use may be removed with a vacuum
cleaner. Particular attention should be paid to the ball base of the
tripod.
Use out-of-doors under adverse conditions will require special
attention. Salt spray should be washed off with fresh water at the
earliest opportunity. Sand and dirt acts as an abrasive and should be
removed using a semi-stiff brush or vacuum cleaner.
If exposed to extreme conditions, sand or grit could enter the tripod.
This will require flushing to remove any contaminants.
Flush the Tripod
1.
Place the tripod in a bucket of clean, 30 cm deep water.
2.
Release the quick release levers and extend tripod fully.
3.
Keeping the feet in the water, collapse and extend the tripod
repeatedly, forcing water through the leg sections until the leg
moves freely with no sign of sticking or contamination.
4.
If required turn the tripod upside down and repeat.
5.
Wipe down the outer surface with a clean dry cloth.
for further
Advertisement
Table of Contents
