Technical Parameters - 2N Access Unit Installation Manual

4. Technical Parameters

Audio
Speaker: 0.8 W / 8 Ω
Interface
Power supply: 12 V ±15 % / 2 A DC (3 A if there is a larger number of modules)
and/or PoE
PoE: PoE 802.3af (Class 0–12.95 W)
LAN: 10/100BASE-TX with Auto-MDIX, RJ-45, connecting block or pigtail RJ-45
Recommended cabling: Cat-5e or higher
Supported protocols: DHCP opt. 66, SMTP, 802.1x, TFTP, HTTP, HTTPS, Syslog
Passive switch: make and break contact, up to 30 V / 1 A AC/DC
Active switch output: 8 to 12 V DC according to power supply (PoE: 10 V;
adapter: source voltage minus 2 V), up to 400 mA
Tamper switch
Inputs: passive / active mode (-30 V to +30 V DC)
OFF = open or U > 1.5 V
ON = short-circuit or U < 1.5 V
RFID card reader
Frequency: 13.56 MHz & 125 kHz
Supported 13.56 MHz cards (only card serial number is read):
ISO/IEC 14443A: Mifare Classic 1k & 4k, DESFire EV1, Mini, Plus S&X,
Ultralight, Ultralight C
ISO/IEC 14443B: CEPAS, HID iCLASS
JIS X 6319: Felica
ISO/IEC 18092: SmartPhone with NFC/HCE support, since Android version
4.3
Supported 125 kHz cards: EM4100, EM4102, HID Prox
2N TELEKOMUNIKACE a.s., www.2n.cz
®
is part of the 2N Access Unit
in
in
90/98