Status Signalling - 2N Access Unit Installation Manual

Connect the electric lock to the
To the active 12 V / 700 mA DC output, or
To the passive output in series with an external power supply.
The device also supports a Departure button connected between the 'PB' and '-
HeliosIP' terminals. Press the Departure button to activate the output for 5 seconds.

Status signalling

Green LED Red LED
flashing off
on off
flashing flashing
on flashing
Configuration:
Connect the Security relay
settings refer to the
sure that one LED at least is on or flashing.
Press and hold the
the programming mode (both the red and green LEDs are flashing).
Activate the output switch using the keypad, telephone, etc. The first code sent
from the intercom will be stored in the memory and considered valid. After code
initialisation, the
flashing).
Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher, it is necessary to reprogram the
®
2N Helios IP Security Relay
2N TELEKOMUNIKACE a.s., www.2n.cz
Security relay
Status
Operational mode
Activated output
Programming mode – waiting for initialisation
Error – wrong code received
to the properly set access unit security output. For
®
2N Access Unit
Security relay Reset button for 5 seconds to put the device in
Security relay will pass into the operational mode (green LED
using the instructions above.
as follows:
Configuration Manual is installed. Make
84/98