Configuring Dnp Serial Channel Properties - ABB COM600 Series User Manual

3.4.3.
22
COM600 series, Version 5.0
DNP 3.0 Serial Slave (OPC) User's Manual
Property / Para- Value or Value range/ Default
meter
Station/Remote Reject commands if position
Switch Error bad or unknown.
Allow commands if position bad
or unknown.
Default: Reject commands if
position bad or unknown

Configuring DNP Serial Channel properties

The DNP Serial Channel properties that can be configured and value ranges for them
can be found in Table 3.4.3-1. The actual configuration by using the SAB600 is performed
as described in 3.2, Overview of configuration.
Table 3.4.3-1 DNP Serial Channel properties
Property / Para- Value or Value range/ Default
meter
Basic
In Use In use
Not in use
Default: In use
Protocol DNP 3.0 Slave
Communication
Port
Description
Defines command handling if the position
is bad or unknown.
Description
Specifies whether the channel is in use or
not.
Protocol
1MRS755495