Troubleshooting - Kanguru KCLONE-7HDS-PRO User Manual

8. TroUbLESHooTING

Problem
The KanguruClone will
not start or there is no
display on the LCD
screen.
The KanguruClone
cannot make copies of a
Master hard drive.
The KanguruClone is
unstable or operates very
slowly.
Possible Cause
The power cable is damaged or
not connected securely.
The voltage of the outlet the
KanguruClone is plugged
into does not match the
KanguruClone.
The power supply switch or the
system power switch is in the
Off position.
The hard drive is not connected
or was not detected by the
Kanguru Clone.
The cables connecting the hard
drive are not connected securely.
The hard drive jumpers are not
set in the correct position.
The hard drive may be faulty.
The hard drive's format is not
supported by Brief Copy or
Resize Copy.
The hard drive contains a Host
Protected Area.
The data cables from the
KanguruClone to the hard drives
are not connected securely.
A hard drive may have an error
that is affecting the other hard
drives, causing slow operation.
The cables do not meet the
UDMA standards.
56
Solution
Make sure that the power cable is not
damaged and is not loose.
Make sure that the voltage of the
outlet matches the voltage of the
KanguruClone.
Make sure that the power switch
located at the back of the unit is in the
On position.
Make sure that all connected hard
drives have been successfully detected
by the KanguruClone.
Make sure that no hard drive
connection cables are loose.
Make sure that all the hard drive
jumpers are set to the Master or Cable
Select position.
Make sure that the Master hard drive is
not broken and does not have errors.
When executing a Brief Copy or
Resize Copy, make sure that the format
of the Master hard drive is supported.
Enable the HPA CHECK option under
the Advanced Setup menu.
Make sure that none of the data or
power cables are loose.
Try to identify the faulty hard drive
and replace as needed.
Only use the cables provided
by Kanguru Solutions with the
KanguruClone.