Duplication; Duplicating From A Master Hdd - Kanguru KCLONE-7HDS-PRO User Manual

3.2 Duplication

The KanguruClone Duplicator can operate in either one of two duplication methods:
• With a Master HDD as the source
• With a Storage Center as the source
Both methods are described in the following sections.

3.2.1 Duplicating From a Master HDD

Using a Master HDD as the Source is the simplest and most convenient way to perform the duplication
process.
IMPorTaNT! Connect all Master and Target hard drives before you execute an operation.
To execute the duplication of a Master HDD:
1. From the Main menu, tap the UP/DoWN buttons to navigate to the desired copy mode. For
more information on the different available copy modes see chapter 3.1 Duplication Modes on
page 13.
The screen will display the following:
Total successful copies
Note: The system will not detect any connected drives before the duplication starts. Therefore
the "Number of Targets detected" value will remain zero until you execute the copy process.
2. Once you have selected the desired copy mode, tap the 'ENT' button to execute. The duplication
process begins as the system initializes the connected disks. After this point the system will be
able to display the number of connected targets correctly.
Number of Targets detected
Current Copy Mode
brIEF CoPy 0
0 PaSS
brIEF CoPy 0
aNaLyZING...
0 FaIL
Total failed copies
16
General Operation