Source Power Off; Erase Source Port; Verify Source Check - Kanguru KCLONE-7HDS-PRO User Manual

6.1.8 Source Power off

The Source Power Off option allows you to configure whether the system turns off power to the
Source drive after a process is completed.
Tap the 'ENT' button to change this option's setting.
• [ ] – Source Power Off is disabled. The system will keep the Source drive powered on after a
process is completed.
• [ ‫٭‬ ] – Source Power Off is enabled (default). The system will shut off power to the Source
drive after a process is completed.

6.1.9 Erase Source Port

The Erase Source port option allows you to configure whether the system erases the disk connected
to the Source port when running Quick Erase, Disk Erase or Disk Wipe.
Tap the 'ENT' button to change this option's setting.
• [ ] – Erase Source Port is disabled (default). A drive connected to the Source port will not be
erased if you run Quick Erase, Disk Erase or Disk Wipe.
• [ ‫٭‬ ] – Erase Source Port is enabled. A drive connected to the Source port will be erased if you
run Quick Erase, Disk Erase or Disk Wipe.

6.1.10 Verify Source Check

The Verify Source Check option allows you to configure whether the system checks the Source's
CRC to ensure that the source data is healthy before starting a copy process.
Tap the 'ENT' button to change this option's setting.
• [ ] – Verify Source Check is disabled (default). The duplicator will not check the Source's
CRC before a copy process.
‫٭‬
• [ ] – Verify Source Check is enabled. The duplicator will check the Source's CRC and ensure
the source data is healthy before starting a copy process.
33
The Setup Menus