Automatically Kick Slow Drives - Kanguru KCLONE-7HDS-PRO User Manual

3.3.2 automatically Kick Slow Drives

You can configure some settings in the Advanced Settings menu that will allow the duplicator to
automatically kick any drives that meet a specific, defined criteria. The options that need to be
configured in the Advanced Setup menu are: Auto Kick Slow, Set Kick Time and Set Kick Speed.
To configure your duplicator to automatically kick slow drives:
1. Navigate to the Advanced Setup menu.
2. Navigate to the option 'Auto Kick Slow'.
3. Enable the 'Auto Kick Slow' option (see section 6.2.8 Auto Kick Slow (15 and 23 target
duplicators only) on page 44).
4. Exit back to the Advanced Setup menu.
5. Navigate to the option 'Set Kick Speed'.
6. Configure the 'Set Kick Speed' option to define the low speed threshold (see section 6.2.10 Set
Kick Speed (15 and 23 target duplicators only) on page 44). Drives that fall below this speed
will be kicked after a designated amount of time.
7. Exit back to the Advanced Setup menu.
8. Navigate to the option 'Set Kick Time'.
9. Configure the 'Set Kick Time' option (see section 6.2.9 Set Kick Time (15 and 23 target
duplicators only) on page 44). Drives that fall below the speed designated in the Set Kick
Speed option for this amount of time will be kicked.
If 'Auto Kick Slow' is enabled, then during a copy, compare or erase operation, any drives that fall
below the 'Set Kick Speed' for the time defined by 'Set Kick Time' will automatically be ejected from
the operation. The red LED will appear next to the ejected drive. Do not disconnect the ejected drive
from the duplicator until the current operation is completed.
22
General Operation