Loading A Master Hdd Image To The Storage Center - Kanguru KCLONE-7HDS-PRO User Manual

3.2.2.2 Loading a Master HDD image to the Storage Center

Once you have formatted a hard drive to act as a Storage Center, you can use the duplicator to load
images of your Master HDD's to the Storage Center. To load a Master HDD image to the Storage
Center:
1. Connect the Storage Center to the Source port.
2. Connect the Master drive you are imaging to the last Target port on the duplicator (either #7, #15
or #23 depending on model).
3. From the Main menu, tap the UP/DoWN buttons to navigate to 'LOAD IMAGE'. You will see
the following screen:
4. Tap the 'ENT' button. The duplicator will initialize the disks and then ask you to input a 3-digit
name for the image file. Up to 127 file names can be saved in the Storage Center.
a) The file name consists of three digits. The digit furthest to the left will be blinking, indicating
that it is currently selected. Tap the UP/DoWN button to increase/decrease the digit by one.
b) Tap the 'ENT' button to select the next digit to the right. Tap the UP/DoWN button to
increase/decrease the digit by one.
Note: If your duplicator displays the error message, "TARGET NOT FORMATTED" then
the hard drive connected to the Source port has not been formatted as a Storage Center yet
(see section 3.2.2.1 Formatting a hard drive as a Storage Center on page 18).
5. When you have completed naming the image file, press and hold the 'ENT' button for three
seconds and the Load process will begin.
Note: If the image file name you entered already exists for an image file previously loaded on
the Storage Center, the system will ask you to confirm overwriting the previously saved file.
Tap the 'ENT' button to confirm or tap the 'ESC' button to cancel.
Amount of data loaded
6. When the load process has completed you can remove the Master HDD.
LoaD IMaGE
0 PaSS
Please input
[001] SELECT IMaGE
LoaD IMaGE 1
2.12G 3%
Percentage completed
19
0 FaIL
Size of Source data
63.63G
143M/s
Data transfer rate
General Operation