Safety and Care Advice Important – Please read these instructions fully before starting assembly • Check you have all the • During assembly do not stand • To reduce the components and tools listed on or put weight on the product, likely hood of the following pages this could cause damage.
Page 3
If you have damaged or missing components, Components - Panels call the Customer Helpline: Please check you have all the panels listed below Top Cabinet (70x30x17.3cm) Legs x4 (5.5x73.2cm) Shelf (3.1x24.3x92.6cm)
Page 4
Components - Fittings Note: The quantities below are the correct amount to completed the assembly. In some cases more fittings may be supplied than are required. M6x65mm Bolt x 12 Spring Washer x 12 Washer x 12 Allen Key x 1 Strap x 1 M6x30mm Wall plug x 1 4x15mm Screw x 2...
Page 5
Assembly Instructions Step 1 Assemble legs Take out drawers. Turn over the top cabinet on smooth and clean surface. Attach legs to top cabinet by bolts , spring washers , washers and Allen key . Do not tighten the bolts.
Page 6
Assembly Instructions Step 2 Assemble shelf Attach shelf legs as shown by bolts , spring washers ,washers and Allen . Do not tighten the bolts. Turn over the cabinet. Tighten all bolts. Put drawers into cabinet.
Page 7
Assembly Instructions Step 3 Fixing to wall It is recommended that the Addington Console is fixed to a wall. Insert screw through strap into pre - drilled hole in product. With help, move Note: Wall plugs supplied Addington Console into are for solid walls only.
A Guide to - Wall Mounting & Fixings When drilling into walls always check that there are no hidden wires or pipes etc. Make sure that the screws and wall plugs being used If plastic wall plugs are suitable for supporting your unit. Consult a qualified are supplied with your tradesperson if you are unsure.
Need help?
Do you have a question about the 239/2352 and is the answer not in the manual?
Questions and answers