Removing And Replacing The Transceiver Pc Board Assembly - Motorola ROKR E2 Service Manual
Digital wireless telephone
Hide thumbs
Also See for ROKR E2:
- Instruction manual (108 pages) ,
- User manual (95 pages) ,
- Manual (48 pages)
Table of Contents
Advertisement
Level 1 and 2 Service Manual
Removing and Replacing the Transceiver PC Board Assembly
6809497A99-O
1.
Remove the SD card, battery cover, battery, SIM, side bands, rear housing, as
described in the procedures.
2.
Carefully lift one side of the transceiver PC board out of the front housing.
3.
Carefully use the disassembly tool to disconnect the display module flex
connector from the transceiver PC board (see Figure 15).
Flex connector
Figure 15. Removing the Transceiver PC Board Assembly
4.
Carefully lift the transceiver PC board out of the front housing.
5.
To replace, align the transceiver PC board assembly to the rear housing and
then lower the transceiver PC board assembly onto the rear housing.
6.
Replace the rear housing, side bands, SIM, battery, battery cover, and SD card
as described in the procedures.
March 27, 2006
Disassembly
Transceiver PC board
Front housing
051982o
33
Advertisement
Table of Contents
Troubleshooting
