Motorola ROKR E2 Service Manual page 38

Disassembly
38
5. Lift the keypad switch PC board away from the transceiver PC board.
6. To replace, align the keypad switch flex connector to its socket on the trans-
ceiver PC board.
7. Gently press the keypad switch flex connector into position until the connector
is properly seated in its socket.
8. Turn the keypad switch PC board over so that the keypad switch is aligned to
the transceiver PC board.
9. Engage the metal latch on one side of the keypad switch PC board to the
transceiver PC board.
10. Engage the metal latch on the other edge of the keypad switch PC board to
secure the keypad switch PC board to the transceiver PC board.
11. Replace the display module assembly, keypad assembly, transceiver PC board
assembly, rear housing, side bands, SIM, battery, battery cover, and SD card
as described in the procedures.
March 27, 2006
E2
6809497A99-O