Table of Contents
Advertisement
Level 1 and 2 Service Manual
Removing and Replacing the Transceiver Board Assembly
G
6809505A64-A
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
1.
Remove the battery cover, battery, USIM, antenna, rear housing and battery
tray as described in the procedures
2.
Use the plastic tweezers to pry loose and remove the vibrator assembly.
3.
Lift the transceiver board assembly out of the front housing with the plastic
tweezers. See Figure 9.
Plastic
Tweezers
Vibrator
Assembly
Figure 9. Disconnecting the Flex from the Transceiver Board
4.
To replace, insert the transceiver board assembly into the rear housing.
IMPORTANT
During reassembly, make sure the PCB is not seated over the acoustic grommet.
5.
Carefully and gently press the transceiver board into position and until it snaps
into place.
6.
Replace the antenna assembly, rear housing, USIM, battery, and battery cover
as described in the procedures.
May 09, 2007
.
Transceiver PC Board
Assembly
IMPORTANT!
During reassembly, make sure
the PCB is not seated over
the acoustic grommet.
Disassembly
061469o
23
Advertisement
Table of Contents
