Intermec CN30 User Manual page 92

Chapter 4 — Network Support
Configuring the Network Parameters for a TCP/IP Network
64
already set up your wireless communications network including your access
points. If you are using a UDP Plus network, you also need to have your
Intermec Application Server communicating with a host computer.
Your CN30 supports these network protocols:
•
TCP/IP
•
UDP Plus
The next sections explain the parameters you need to configure for the
CN30 to work in your wireless network.
In a TCP/IP network, the CN30 communicates with a host computer
directly using TCP/IP. The access point acts as a bridge to allow communi-
cations between the wired network and the wireless network.
To use wireless communications in a TCP/IP network
1 Configure these network parameters on each CN30 in the
•
Network Name (SSID)
•
IP Settings (if not using DHCP)
2 Configure security. For help, see "Configuring Security" on page XX.
work.
You can configure the network parameters on the CN30 with the Configu-
ration Utility. For help, see "Configuring the CN30 with the Configuration
Utility" on page XX.
CN30 Mobile Computer User's Manual
network: