Intermec CN30 User Manual page 22

Chapter 1 — Using the CN30 Mobile Computer
Resetting Your CN30 Mobile Computer
Performing a Warm-Boot on the CN30 Computer
Performing a Cold-Boot on the CN30 Computer
Reset Button
12
In some cases where the CN30 Mobile Computer completely stops
responding, it may be necessary to perform a cold reset. Because cold reset-
ting may result in data loss, it is not recommended unless all other recovery
methods have failed.
If your charged CN30 Computer does not resume after pressing (I), or if
the computer or an application is locked up, you may need to do a warm-
boot.
• Press and hold (I) for five to ten seconds, until the screen goes black.
The CN30 Computer tells you it is performing a warm-boot, then comes
back up to the start screen.
If the CN30 Computer or an application is locked up and does not respond
to a warm-boot, do the following.
1 Release the lower clip of the hand strap and slide the latch to the left.
2 Remove the keypad module.
3 Press the Reset button located inside the console module.
4 Reinstall the keypad module.
CN30 Console
CN30 Mobile Computer User's Manual