Intermec CN30 User Manual page 80

Chapter 2 — Windows Mobile Version 5. 0
52
or "Shared" when WEP keys are required for association.
b Set Data Encryption to "Disabled."
To Enable WEPEncryption
Set Authentication to either "Open" if WEP keys are notrequired; or
"Shared" when WEP keys are required for association.
bSet Data Encryption to "WEP."
cTo change the network key, clear The Key is provided for me automati-
cally box, then enter the new Network key andselect the appropriate Key
index.
Note: The following information applies when you have Enable Microsoft's
Wireless Zero Config checked via the Wireless Network control panel
applet.
To EnableWPA Authentication
a Set Authentication to "WPA." See page 364 for information about WPA
encryption.
b Set Data Encryption to either "WEP" or "TKIP." See page 364 for infor-
mation about WEP and TKIP encryption.
To EnableWPA Authentication Using a Preshared Key (puters) a Set
Authentication to "WPA-PSK." See page 364 for information about WPA
encryption.
b Set Data Encryption to either "WEP" or "TKIP." See page 364 for infor-
mation about WEP and TKIP encryption.
c Enter the new Network key.
5 Tap the 802.1x tab, select either "PEAP" or "Smart Card or Certificate"
for the EAP type,then tap Properties to adjust its settings.
6Tap ok to return to the Configure Wireless Network screen.
7From the Networks to access drop-down list, select "All Available," "Only
access points," or "Only computer-to-computer" depending on thety-
peofnetworks to which youconnect.
To connect only to networks you have already configured, clear Automati-
callyconnect to non-preferred networks. Tap ok to close this screen.
Note: If you select to automatically connect to non-preferred networks,
your device detects any new networks and provide you the opportunity to
configure them.
CN30 Mobile Computer User's Manual