Required Tools - Emerson FB1200 Instruction Manual

Emerson FB1200 Flow Computer Instruction Manual
D301782X012
July 2017
Table 2-1: Environmental Specifications
Specification
Ambient Temperature
Maximum Process Connection
Temperature
Humidity
Vibration
2.3

Required Tools

Certain tools and equipment are required for installing and servicing the flow computer.
Table 2-2: Required Tools
Tool
Torque wrench
2.5 mm hexagonal wrench
3 mm hexagonal wrench
9/16 in hexagonal wrench
1 1/16 in combination wrench
High-wattage soldering iron and solder
#1 Phillips-head screwdriver
#2 Phillips-head screwdriver
1/8 inch flat-head screwdriver
1/16-inch flat head screwdriver
Laptop PC running Field Tools with FBxConnect
configuration software
12
Range
-40°C to +80 °C (-40 °F to +176 °F ) - no battery, C1D1/C1D2
-40°C to +60 °C (-40°F to +140 °F ) – lead acid battery, C1D1/C1D2
-40°C to +80 °C (-40 °F to +176 °F ) – no battery, ATEX/IEC Ex d
-25 °C to +80 °C (-13 °F to +176 °F ) – no battery, ATEX/IEC Ex nA
120 °C (248 °F)
5% to 95% non-condensing
2g over 10 to 150 Hz; 1g over 150 to 200 Hz
Use
For bolting/mounting the flow computer
For manipulating rotation set screw
For screw for M4 x 0.7 end cap retaining clamp (ATEX
required)
For installing/removing ¾ in NPT conduit plugs
For installing/removing ¾ in NPT to M20 thread
reducer (ATEX required)
For tinning ground connection wire
For screws on HMI module
For screws on other modules and boards
For 5.08 mm pitch terminal block connections
For 3.81 mm pitch terminal block connections
For software configuration
Installation