Network Tab; Tab; Front Panel Tab; System Tab - Lightware MX2-8X8-HDMI20-AUDIO User Manual


  
6. Software Control – Using Lightware Device Controller
6.6.2. Network Tab
Network-related settings are available on the tab.
When dynamic IP address is used, the DHCP option is ticked; the IP settings of the matrix is shown in the
first three lines. When static IP address is used, the DHCP option shall be unticked and below three lines
can be used to define the IP settings. The device can be controlled by LW3, LW2 protocols, or P#2 protocol.
ATTENTION! Connecting to the matrix via Ethernet and using LW2 port no. (default is 10001) the device
accepts LW2 protocol commands. Using LW3 port no. (default is 6107) the device accepts LW3 protocol
commands.
6.6.3. RS-232 Tab
The local RS-232 port settings are available on this tab.
Network Tab in the Settings Menu
RS-232 Tab in the Settings Menu
MX2-8x8-HDMI20 series – User's Manual
6.6.4. Front Panel Tab
Certain settings in connection with the front panel LCD are available in the LDC as well.
LCD brightness: the slider can be set to 0 contrary to the front panel menu. When the value is 0, the LCD
▪
is totally dark.
▪ Lock front panel: the same as the Control lock button on the front panel.
Enable buzzer: enable/disable the built-in beeper.
▪
▪ Find my device: the matrix buzzer beeps shortly three times.
6.6.5. System Tab
The following settings are available on this tab:
▪ Loading factory default settings,
▪ Rebooting the device,
Setting the time (internal clock) of the matrix which is used for logging events.
▪
ATTENTION! The internal clock is supplied by a button cell when the device is switched off. If the set time
is changed unintentionally or you met any weird behavior in connection with the internal clock, please
contact support@lightware.eu.
Front Panel Tab in the Settings Menu
32