Cable Connectors - FLIR Quasar Gen II Series CM-6212 H1-I User And Installation Manual

3.3

Cable Connectors

The camera is shipped with an Ethernet cable for network and Power over Ethernet (PoE) connection and a
system cable for ground, power, I/O, and audio connections. The figure below shows the various
connectors included with the camera. The connectors, pin numbers and signal definitions are listed below.
No. Cable
1 Audio I/O
2 Power (12VDC)
(2-pin Terminal Block)
3 Alarm I/O
(4-pin Terminal Block)
4 GND
5 Ethernet Cable
The alarm input and output connectors are shown below
Pin No. Designation
1 Alarm In (-)
2 Alarm In (+)
3 Alarm Out (-)
4 Alarm Out (+)
September 6, 2017
CM-6212 Camera Input/Output Connections
Pin Definition
Pink Audio In
Green Audio Out
Black
Red DC 12V +
1
2 Alarm In +
3
4 Alarm Out +
- GND
- RJ45 connector with LEDs for network and PoE connections.
CM-6212 H1-I User and Installation Guide
Remarks
Two-way audio transmission
Power connection
Alarm connection
Ground connection
.
Hardware Description
13