Card Reader - 2N Access Unit Configuration Manual

In case of use external relay
commands:
To turn on the switch -
http://192.168.1.10/state.xml?relayState=1
To turn on for pre-defined time (default value is 1.5 s) - http://ip_address
/state.xml?relayState=2
To turn off -
168.1.10/state.xml?relayState=0
In case of use external relay
(Symbol X should be replaced with a number of the desired switch):
To turn on the switch -
http://192.168.1.10/state.xml?relay1State=1
To turn on for pre-defined time (default value is 1.5 s) - http://ip_address
/state.xml?relayXState=2
)
To turn off -
168.1.10/state.xml?relay1State=0
5.3.2 Audio
Key beep volume – set the key beep volume. The volume values are relative
against the set master volume.
Warning tone volume – set the volume of warning and signalling tones described
in the Signalling of Operational Statuses
against the set master volume.
Switch activation tone volume – set the volume of the switch activation tone.
The volume values are relative against the set master volume.

5.3.3 Card Reader

2N TELEKOMUNIKACE a.s., www.2n.cz
part no.: 9137410E
http://ip_address/state.xml?relayState=1
(e.g.: http://192.168.1.10/state.xml?relayState=2
http://ip_address/state.xml?relayState=0
)
part no.: 9137411E
http://ip_address/state.xml?relayXState=1
(e.g.: http://192.168.1.10/state.xml?relay1State=2
http://ip_address/state.xml?relayXState=0
)
are used next HTTP
)
are used next HTTP commands
)
section. The volume values are relative
(e.g.:
)
(e.g.: http://192.
(e.g.:
(e.g.: http://192.
37/84