Card Reader Module Configuration - 2N Access Unit Configuration Manual

Card Reader Module Configuration

Module name - set the module name for card reader logging purposes.
HID card format - set the type of HID Prox card to be accepted by the card
reader. The card reader supports just one card type at an instant. This setting is
not applied if you do not use the HID Prox cards. (The parameters is available for
125kHz card readers only).
Associated switch – set the number of the switch to be activated by tapping of a
valid RFID card. The set value is not applied when a valid user card is tapped on
the reader while the double authentication mode is enabled. In this case, a
numeric switch activating code is required to identify the switch to be activated.
Card read signalling - set one of the card reading signalling modes:
acoustic signals distinguish valid/invalid cards,
both valid and invalid cards,
Forward to Wiegand output - set a group of Wiegand outputs to which all the
received RFID card IDs will be resent.
2N TELEKOMUNIKACE a.s., www.2n.cz
None - acoustic signalling is disabled.
Single beep - one beep signals
Full -
45/84