Unpacking; Included Accessories - K-array KA14 User Manual

KA14
• Since the device is a CLASS I apparatus, it must be only connected to an AC
If your outlet isn't grounded, contact a licensed electrician to replace it with a property grounded
outlet.
• To reduce the risk of electric
audio cable. Reconnect the power cord only after making all signal connections. Do not use the product
if the power cord is broken or frayed. Protect the power cord from being walked upon or pinched.
• To completely disconnect this apparatus from the ac mains,
from the ac mains connector.
• Voltage requirement. Make sure that the supplied voltage stays within the specified range. Verify that
your mains connection satisfies the power ratings of the device.
• Only connect the power supply to an
• Do not install the amplifier in
• TO REDUCE THE
and objects filled with liquids, such as vases, should not be placed on this apparatus.
• The main plug of the power supply cord shall remain readily accessible.
• Choking Hazards. This device contains small parts, which may present a choking hazard to small
children. Keep the device and its accessories away from small children.
• Temperature. Operate the device in a place where the temperature is between -20°C and 35°C (-4°F
to 95° F). Avoid dramatic changes in temperature or humidity when using it, as condensation may
form on or within the device.
• Do not make repairs
potentially hazardous voltage. Never attempt to disassemble, repair or modify the system yourself.
Disassembling the unit may cause damage that is not covered under the warranty. The device contains
no user-serviceable parts.
not plug the power cord in if you suspect that your device needs service or repair.

5. UNPACKING

Each K-array amplifier is built to the highest
standard and is thoroughly inspected before
leaving the factory. Upon arrival, carefully inspect
the shipping carton, then examine and test your
new amplifier. If you find any damage, immediately
notify the shipping company. Only the consignee
may institute a claim procedure regarding the
system's electronic equipment.
6
shock, disconnect the amplifier from the AC mains power before installing
wet or humid locations
RISK OF FIRE OR ELECTRIC
yourself. Caution, risk of electric shock. Do not open the device, it contains
Repairs should only be performed by factory trained service personnel.
wARNING
appropriate power outlet.
without using weather protection.
SHOCK, do not expose this apparatus to rain or moisture
CAUTION

6. INCLUDED ACCESSoRIES

• Power cable
• USB cable
• Rubber pads for flat surfaces installation
• Rack brackets
three-wire grounding
disconnect the power supply
Ver. 1.2
outlet.
cord plug
Do