Fixture Id And Rdm; Wireless Control Settings; Fixture Settings - Prolight LUMA700 User Manual

Moving head
Table of Contents

Advertisement

Available languages

Available languages

3.19 FIXTURE ID AND RDM

With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. Manual settings like adjusting the DMX starting address are
no longer needed. This is especially useful when the device is installed in a remote area. RDM is integrated
in DMX without influencing the connections. The RDM-data is transmitted via the standard XLR-poles 1
and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX devices can be operated
in one DMX line. The RDM protocol sends own packages in the DMX512 data feed and does not influence
conventional devices. If DMX splitters are used and RDM control is to be used, these splitters must sup-
port RDM. The number and type of RDM parameters depend on the RDM controller (not included) is used.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Connect icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, and then select the RDM ID and press the ENTER
button to enter the next menu.
• Press UP/DOWN button to scroll through the menu, then select Password and press ENTER to confirm.
• Use the arrow keys to enter the password 050 and press ENTER to confirm.
• Once you have entered your password, you can set the PID Code, necessary to control the unit with the
RDM protocol. Press the UP/DOWN button to scroll through the menu, select PID Code and press EN-
TER to confirm.
• Use the arrow keys to enter the PID Code, then press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.

3.20 WIRELESS CONTROL SETTINGS

To enable wireless control mode, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Connect icon, then press the ENTER button to
enter the next menu Address.
• Press the UP/DOWN button to scroll through the menu, select W-DMX and press ENTER.
• Press the UP/DOWN and LEFT/RIGHT buttons to select the desired value (001-512).
• Press the ENTER key to confirm the setting.
To change the settings of wireless control, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Connect icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select Wireless, and press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to select the option proposed and press the ENTER button to confirm your
choice.
- DMX Out - Disable/enable the DMX signal cable. Select OFF to deactivate or ON to activate the func-
tion.
- Reset Connect - Reset the wireless connection of the unit. Select OFF to deactivate or ON to activate
the function.
• Press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.

3.21 FIXTURE SETTINGS

You can change the parameters for the device by following these steps:
LUMA700
29

Advertisement

Chapters

Table of Contents
loading

Table of Contents