Installing The Flight Battery; Transmitter And Receiver Binding - BNF Blade mCP Instruction Manual

Installing the Flight Battery

1
1. Lower the throttle stick to the lowest position.
2. Power ON the transmitter.
3. Center all trims. For the included MLP6 transmitter
(RTF only), the trims are centered when you hear a
longer tone while pressing the trim button. Move the
trim in both directions until you hear the long tone.
4. Install the fl ight battery in the battery holder on the
bottom of the helicopter frame.
5. Connect the fl ight control power lead to the battery
connector.
CAUTION: Connecting the battery to the fl ight
control board with reversed polarity will cause
damage to the control board, the battery or both. Dam-
age caused by incorrectly connecting the battery is not
covered under warranty.

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique Identifi er)
code of a single specifi c transmitter. You need to 'bind' your chosen Spektrum
aircraft transmitter to the receiver for proper operation.
If you purchased an RTF model, the transmitter is bound to the model at the factory.
If for any reason you need to re-bind your mCP S to the MLP6DSM, follow the directions below:
Binding Procedure for the MLP6DSM (RTF)
1. Disconnect the fl ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the fl ight battery to the helicopter. The 3-in-1 Control unit LED fl ashes after 5 seconds.
4. Push and hold the "panic" trigger/button and hold the rudder control stick to full left while powering on the transmitter.
5. Release the trainer switch/button. Continue to hold the rudder control stick to full left until the blue LED on the 3-in-1
control unit is solid.
6. Release the rudder control stick.
7. Push the trainer switch/button. The blue LED on the 3-in-1 control unit fl ashes to confi rm the helicopter is in
non-computer mode.
8. Disconnect the fl ight battery and power the transmitter off.
NOTICE: If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer
transmitter mode. Repeat the binding procedure.
EN
2
4
6. Place the helicopter on a
fl at surface and leave it still
until the receiver LED glows solid,
indicating initialization is complete.
If you experience problems during initialization, refer to the
Troubleshooting Guide at the back of the manual.
CAUTION: Always disconnect the Li-Po battery
from the aircraft when not fl ying to avoid
over-discharging the battery. Batteries discharged to a
voltage lower than the lowest approved voltage may
become damaged, resulting in loss of performance and
potential fi re when batteries are charged.
™
DSM2
8
5
® ®
/ DSMX technology equipped