Installing The Transmitter Batteries (Rtf); Transmitter Control (Rtf) - BNF Blade mCP Instruction Manual

Installing the Transmitter Batteries (RTF)

The LED indicator fl ashes and the transmitter
beeps progressively faster as the battery voltage
drops.
Replace the transmitter batteries when the
transmitter begins to beep.

Transmitter Control (RTF)

Flight mode switch
Bind switch
Adjusting Flight Trims
When pressed down, trim buttons make a sound that
increases or decreases in pitch at each pressing. The
middle or neutral trim position is heard as a middle tone in
the pitch range of the sounds. The end of the control range
is sounded by a series of beeps.
Aileron (Left/Right)
Mode 1 Throttle/Collective
(Up/Down)
Aileron (Left/Right)
Mode 2
Elevator (Up/Down)
F
E E
D
A B
Throttle
Trim
Elevator
Trim
Power LED/fl ight
mode indicator
ON/OFF
Switch
Dual Rate Selection
The control sensitivity can be changed by pressing and
releasing the right control stick. The LED on the transmitter
will show solid for high sensitivity (default) and fl ashing for
low sensitivity.
C D
Aileron Rudder
Trim Trim
Aileron Rudder
Trim Trim
5
Panic Recovery
A
B
C
E
Elevator Rudder (Left/Right)
Trim Elevator (Up/Down)
Rudder (Left/Right)
Throttle
Throttle/Collective
Trim
(Up/Down)
Dual rate
switch
F
EN