Installing The Flight Battery; Transmitter And Receiver Binding - BNF BLADE UMX F27 FPV Instruction Manual

Installing the Flight Battery

1. Remove the canopy.
2. Insert the fl ight battery in the battery compartment.
The recommended battery is a snug fi t and should not
require any other means of restraint. If the battery fi ts
loosely in the battery compartment, apply hook and
loop material to the battery and inside the compart-
ment to hold the battery in place.
3. Connect the battery connector to the aircraft power
lead, noting correct polarity.
CAUTION: Connecting the battery to the ESC with
reversed polarity will cause damage to the ESC,
the battery or both. Damage caused by incorrectly
connecting the battery is not covered under warranty.
4. Keep the aircraft upright, level, out of the wind and
immobile for approximately 10 seconds, until the
receiver initializes. The ESC will emit a series of tones
and the LED on the receiver will light.
5. Replace the center section cover.
If you have not previously bound the aircraft to your
transmitter the LED on the receiver will rapidly fl ash red.
Proceed to the Transmitter and Receiver Binding section.
If the receiver does not fully initialize, re-bind the receiver
to your transmitter as shown in the Transmitter and
Receiver Binding section.

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the
control unit to recognize the GUID (Globally Unique Identifi er)
code of a single specifi c transmitter. You need to 'bind' your
™
chosen Spektrum DSM2
aircraft transmitter to the receiver for proper operation.
If you encounter problems, obey binding instructions and
refer to your transmitter troubleshooting guide for other
instructions. If needed, contact the appropriate Horizon
Product Support offi ce for further assistance.
CAUTION: Always keep hands away from the
propeller. When the aircraft is armed, the motor
will turn the propeller in response to any
throttle stick input.
® ®
/DSMX technology equipped
Binding Procedure
1. Disconnect the fl ight battery.
2. Power off the transmitter.
3. Connect the fl ight battery in the aircraft. The aircraft
will beep and the receiver LED will rapidly fl ash red
indicating the receiver is in bind mode.
4. Make sure transmitter controls are neutral and the
throttle is at the lowest setting with the throttle trim at
or below the middle.
5. Put your transmitter into bind mode. Refer to your
transmitter manual for binding instructions.
6. The receiver LED will glow solid, indicating that the
receiver is bound to the transmitter. If the LED does not
glow solid, refer to the Troubleshooting Guide section.
5
Receiver LED
EN