Table of Contents
Advertisement
Monogramming and embroi-
EN
dering with embroidery hoop
Embroidery hoop available as optional
accessorie
· Set the machine as illustrated.
· Pattern selector on " "
· Remove the presser foot and the
presser foot holder.
· Move the drop feed control to right
side to lower the feed dogs. (1)
· Lower presser foot lever before starting
to sew.
· Turn the stitch length dial to "0".
· Adjust the stitch width according to
the size of lettering or design.
Preparation for Monogramming and
Embroidering
· Draw the desired lettering or design on
the right side of the fabric.
· Stretch the fabric between embroidery
hoop as firmly as possible.
· Place the fabric under the needle.
Make sure the presser foot bar is down
in its lowest position.
· Turn the balance wheel towards you to
bring up the lower thread through the
fabric. Sew a few securing stitches at
the starting point.
· Hold the hoop with both hands and
guide it
Move drop feed control to the left side for
normal use
EN
Quilt stitch
Set the machine as illustrated.
Turn the stitch width dial and stitch length
dial to suit the fabric.
Stitch length control "4"
Stitch width control "3" - "7" (model
65/80e/90e)
Quilt (1)
Pattern selector on " "
For all fabrics and all types of work.
(model80e/90e)
Quilt (2)
Pattern selector on " "
For all fabrics and all types of work.
(model 80e/90e)
Hand look quilt stitch (3)
Pattern selector on " "
For all fabrics and all types of work which
should have a hand-sewn look.
(model 80e/90e)
The bobbin thread must come through the
right side. Depending on the fabric used
increase the upper tension.
Use monofilament thread 0 hand stitch
effect.
Balance, adjust if necessary
Hide quick links:
Advertisement
Table of Contents
