Screen Design Software - Omron NV Series Setup Manual

Models
1-3-2

Screen Design Software

Name
CX-One version 4.@
CX-One Lite version 4.@
Programming Device Connecting
Cable for NV3W
Computer end (RS-232C connector)
USB-Serial Conversion Cable
Programming Device Connecting
Cable for NV3W-V1 or NV4W
Programming Device Connecting
Cable for NV3Q
10
The NV-Designer is used as the Screen Design Software for the NV-series
PTs.
The NV-Designer is included in CX-One version 4.@ or in CX-One Lite version
4.@.
Personal computer
CX-One version 4.@ or
CX-One Lite version 4.@
• The NV3W is connected using an NV-TOL-3M RS-232C Cable with a
round DIN pin connector on the NV end.
To connect to a USB connector on the computer, connect the NV-TOL-3M
cable through a CS1W-CIF31 USB-Serial Conversion Cable.
• You can connect to the NV3W-V1, NV4W or NV3Q using a commercially
available USB cable.
Includes the NV-Designer.
For the NV3W (sold separately) RS-232C cable
with a round DIN pin connector on the NV3W end
PT end
For the NV3W (sold separately)
Use this Cable together with the NV-TOL-3M to
connect to a USB connector on the computer.
Computer end (USB connector)
Note The enclosed USB driver must be installed.
For the NV3W-V1 or NV4W (sold separately)
(USB: Type mini-B)
For the NV3Q (sold separately)
(USB: Type B)
NV-Designer Screen
Design Software
Project data is transferred.
Description
PT end
Section 1-3
NV
Model
On CD: CXONE-AL01C-V4
On DVD: CXONE-AL01D-V4
On CD: CXONE-LT01C-V4
NV-TOL-3M
CS1W-CIF31
Commercially available USB
cable
Commercially available USB
cable