Configuration Settings From The System Menu - Omron NV Series Setup Manual

Configuration Settings from the System Menu

5-1 Configuration Settings from the System Menu
5-1-1 Accessing the System Menu
1,2,3...
80
The System Menu on the PT is used to configure the PT. The following set-
tings can be made: communications, PT clock, LCD contrast, etc. Not all of
the settings in the PT Configuration can be set from the System Menu. The
System Menu is operated using the touch switches on the front panel of the
PT.
Refer to the NV-series Programming Manual (Cat. No. V104) when setting the
NV Configuration of a NV-series PT from the NV-Designer.
Use the following procedure to access the System Menu.
1. Touch the touch panel on the PT as shown below.
NV
A B
C
Touch A for 2 s and then B
and C in order.
Precautions for Correct Operation
Touch points A, B, and C one at a time in order. Do not press these switches at
the same time. They must be pressed in order.
2. The startup screen of the System Menu will be displayed.
The System Menu depends on the model of PT and the registered
screens.
The default System Menu for the NV3W is used here.
The system version is the version of the sys-
tem ROM in the PT.
Section 5-1
1. Touch the upper left corner (A) for
at least 2 seconds.
2. Then immediately touch the upper
right corner (B) and lower right cor-
ner (C) in order.
Note
(1) If you are using vertical dis-
plays, touch the upper left, up-
per right, and then lower right
corners in the same way with
the PT oriented vertically.
(2) The System Menu cannot be
displayed vertically. It will al-
ways be display horizontally.
The initial screen of the PT's System
Menu will be displayed. The next
screen will be displayed if you touch
the Setting or Test Key. To return to
normal operating status, touch the
ESC Key.