Registering The Screen Data - Omron NT620S Operation Manual

Registering the Screen Data

3-6 Registering the Screen Data
Transmission – Transmission in File Units
Transmitting the Screen Data from the Support Tool
Reference
The screen data is created by using the support tool and registered to the
NT620S/620C screen data memory. This section describes the procedure to
register the screen data to the NT620S/620C. For the screen data creation and
the support tool operation, refer to the NT-series Support Tool Operation Manual
(V028-E1-j).
The NT620S/620C uses several screens which are switched on its display. The
screen data of one NT620S/620C unit corresponds to the files created by using
the support tool. Select a file which contains the screen data to be transmitted
when selecting the screen data to be transmitted to the NT620S/620C so that the
required screen data can be transmitted to the NT620S/620C.
Screen data file
Screen 1
Screen 2
:
Screen N
Memory table
Mark data
System memory
Direct connection
information
When screen data is transmitted from the support tool to the NT620S/620C, all
existing screen data in the NT620S/NT620C is deleted.
Transmission in screen units is not possible with the NT620S/620C.
If an error message and the System Menu are displayed immediately after the
NT620S/620C has been started, the screen data memory needs to be initialized.
To transmit the screen data from the support tool to the NT620S/620C, connect
the NT620S/620C to the computer on which the support tool is being used, and
follow the procedure below.
- When screen data transmission is performed, the NT620S/620C screen data
memory is automatically initialized before the new screen data is transmitted.
There is therefore no need to initialize the screen data memory using menu
operations before transmitting the screen data.
- The NT620S/620C uses the same connector for screen data transmission and
connection to the PC. If the NT620S/620C is currently connected to the PC,
disconnect the PC cable and connect the support tool (personal computer)
cable to this connector before attempting screen data transmission.
All screen data are
transmitted by one operation.
Section 3-6
NT620S/620C
Screen 1
Screen 2
:
Screen N
Memory table
Mark data
System memory
Direct connection
information
77