Installation of outdoor unit
Step one: fix the support of outdoor unit
(select it according to the actual installation situation)
1. Select installation location according to the house structure.
2. Fix the support of outdoor unit on the selected location with
expansion screws.
Note:
• Take sufficient protective measures when
installing the outdoor unit.
• Make sure the support can withstand at least
four times the unit weight.
• The outdoor unit should be installed at least
3cm above the floor in order to install drain
joint.
• Expansion screws needed per type of unit:
Cooling capacity
2300-5000W
6000-8000W
10000-16000W
Step two: install drain joint
(Only for cooling and heating unit)
1.Connect the outdoor drain joint
into the hole on the chassis, as
shown in the picture below.
2. Connect the drain hose into the
drain vent.
Drain vent
Drain hose
# screws
6
8
10
Chassis
Outdoor drain joint
at least 3cm above the floor
Step three: fix outdoor unit
1. Place the outdoor unit on the
support.
2. Fix the foot holes of outdoor unit
with bolts.
Foot holes
Foot holes
27