Gree GWC09MB-D3DNK Series Owner's Manual page 30

26
Installation of indoor unit
Step Eight: bind up pipe
1. Bind up the connection pipe,
power cord and drain hose with
the band.
indoor units
2.Reserve a certain length of drain
hose and power cord for installation
when binding them. When binding
to a certain degree, separate the
indoor power and then separate the
drain hose.
Step Nine: hang the indoor unit
1.Put the bound pipes in the wall pipe and then make them pass through
the wall hole.
2.Hang the indoor unit on the wall-mounting frame.
3.Stuff the gap between pipes and wall hole with sealing gum.
4.Fix the wall pipe.
5.Check if the indoor unit is installed firmly and close to the wall.
indoor
wall pipe
Note:
• Do not bend the drain hose too excessively in order to prevent
blocking.
indoor and
outdoor power cord
gas
pipe
liquid pipe
band
drain hose
outdoor
sealing gum
connection pipe
indoor power cord
3.Bind them evenly.
4.The liquid pipe and gas pipe
should be bound separately at the
end.
Note:
• The power cord and control wire
can't be crossed or winded.
• The drain hose should be bound
at the bottom.
Lower hook of
wall-mounting frame
drain hose band
upper hook