Installation Of Outdoor Unit - Gree GVC36ALXH-K3NTC7A Service Manual

Service Manual
Step six: connect wire of indoor unit
1. Make the power connection wire go through the cable-
cross hole of indoor unit(As show in Fig.11)
power
connection
wire
2. Remove the wire clip; connect the power connection wire
to the wiring terminal according to the color; tighten the screw
and then fix the power supply wire,power connection wire with
wire clip.(As show in Fig.12)
Fig.12
Note:the wiring board is for reference only,please refer to the
actual one.
3. Adjust the position of upper and lower adjusting baffle;
clamp the connection pipe and drain pipe as firm as
possible.
4. Tighten the screws.
Note:
All wires of indoor unit and outdoor unit should be connected
by a professional.
1.If the length of power connection wire is insufficient, please
contact the supplier for a new one. Avoid extending the wire
by yourself.
2.For the air conditioner with plug, the plug should be
reachable after finishing installation.
3.For the air conditioner without plug, an air switch must be
installed in the line. The air switch should be all-pole parting
and the contact parting distance should be more than 3mm.
Step seven: bind up pipe
1. Bind up the connection pipe, power cord and drain hose with
the band.(As show in Fig.13)
2.Reserve a certain length of drain hose and power cord for
installation when binding them. When binding to a certain
degree, separate the indoor power and then separate the drain
hose.(As show in Fig.14)
3. Bind them evenly.
4. The liquid pipe and gas pipe should be bound separately at
the end.
Installation and Maintenance
cable-cross
hole
Fig.11
N(1) 2 3
blue black brown yellow-
green
Outdoor unit connection
indoor unit
Fig.13
drain hose
connection pipe
indoor power cord
Fig.14
Note:
1.The power cord and control wire can't be crossed or winding.
2.The drain hose should be bound at the bottom.
Step Eight: place the indoor unit
1.Put the bound pipes in the wall pipe and then make them
pass through the wall hole.
2. Stuff the gap between pipes and wall hole with sealing gum.
(As show in Fig.15)
3. Fix the wall pipe.
4.Check if the indoor unit is installed firmly.
indoor
wall pipe
Note:
Do not bend the drain hose too excessively in order to
prevent blocking.

8.6 Installation of Outdoor Unit

Step one: fix the support of outdoor unit (select it
according to the actual installation situation)
1. Select installation location according to the house structure.
2. Fix the support of outdoor unit on the selected location with
expansion screws.
indoor and outdoor power cord
gas pipe
liquid pipe
band
drain hose
band
outdoor
sealing gum
Fig.15
41