KEYES ROSTOK Manual And Manual page 78































5 Proposed EEPROM configuration codes
5.1 M500: Store parameters in EEPROM
o
5.2 M501: Read parameters from EEPROM
o
5.3 M502: Revert to the default "factory settings."
o
5.4 M503: Get settings
o

6 Replies from the RepRap machine to the host computer
4.4.72 M160: Number of mixed materials
4.4.73 M190: Wait for bed temperature to reach target temp
4.4.74 M200 - Set filament diameter / Get Endstop Status
4.4.75 M201 - Set max printing acceleration
4.4.76 M202 - Set max travel acceleration
4.4.77 M203 - Set maximum feedrate
4.4.78 M204 - Set default acceleration
4.4.79 M205 - Advanced settings
4.4.80 M206: Set home offset
4.4.81 M207: Calibrate z axis by detecting z max length
4.4.82 M208: Set XYZ axis max travel
4.4.83 M209: Enable automatic retract（Retraction）
4.4.84 M220: Set speed factor override percentage
4.4.85 M221: Set extrude factor override percentage
4.4.86 M226: Gcode Initiated Pause
4.4.87 M227: Enable Automatic Reverse and Prime
4.4.88 M228: Disable Automatic Reverse and Prime
4.4.89 M229: Enable Automatic Reverse and Prime
4.4.90 M230: Disable / Enable Wait for Temperature Change
4.4.91 M240: Start conveyor belt motor / Echo off
4.4.92 M241: Stop conveyor belt motor / echo on
4.4.93 M245: Start cooler
4.4.94 M246: Stop cooler
4.4.95 M300: Play beep sound
4.4.96 M301: Set PID parameters - Hot End
4.4.97 M303: Run PID tuning
4.4.98 M304: Set PID parameters - Bed
4.4.99 M420: Set RGB Colors as PWM
4.4.100 T: Select tool
76