KEYES ROSTOK Manual And Manual page 42

3. Balance adjustment:
Before balance adjustment, please make sure printer installation has finished and
the machine is under normal operation. When step 1 and step 2 are finished,
please double check and make sure nothing has been left out and the printer can
operate normally. Then turn on power switch. PC and printer are properly
connected , please prepare a piece of A4 paper.
adjustment before, we suggest you read through tutorial course on leveling before
adjustment in case the machine were damaged by any faulty operation.)
A: Locate the lowest point
When the lowest point is located, please check the distance from nozzle to hotbed
in case nozzle were damaged.
Send script 1 via shortcut key CTRL+ALT+1 to make printer nozzle drop to the
lowest point of X axis. When the dropping process is finished, observe the
distance between nozzle and glass panel. Then send script 2 and script 3
commands as well and observe the distance between nozzle and glass panel. (As
shown below) locate the lowest axis, (below we take X axis as example).
Lowest point of X axis
(If you have never done balance
Lowest point of Y axis
40