Easy Use Of Repetier-Host Software; Repetier-Host Overview - KEYES ROSTOK Manual And Manual

6. If the value gets bigger and bigger according to the above method and there is still height between the
nozzle and the hotbed, please check the line #define MANUAL_Z_HOME_POS 273mm in firmware file
Configuration.h as shown in below picture. First, use a ruler to measure the height between nozzle and
hotbed when nozzle is at its highest position. If the height is more than 273mm, change the value here to the
actual measured value. For example, if the actual measured height is 274mm, change the code into: #define
MANUAL_Z_HOME_POS 274.
Of course, there is another way to do this without changing the firmware parameters. See below picture; add
a screw to the arrow indicated area; and if one axis adds a screw, other two axes need screws too. For
example, if the the height between the nozzle and the hotbed is 1MM, the distance between the screw and the
microswitch is 1MM. After the adjustment, do the test print to see if it works.

7. Easy use of Repetier-Host software

(Examples base on version Repetier-Host 1.06)

1. Repetier-Host overview

Repetier Host is an easy to use software for 3D printing. The main functions include manual debugging
49