Table of Contents
Advertisement
Then, click the "Toggle log" button
You can see below interface
3). Manually control the motor movement
1） See if the installation is correct by manually control the motor rotate direction using buttons of X,Y,Z
and extruder 1.
Click X on the right, extruder moves to the right; move to the left if click the left one.
Click Y on the above, hotbed moves backward; moves forward if click the below one.
Click Z on the above, nozzle moves upward; moves downward if click the below one.
Click nozzle on the above, nozzle motor moves reversely; moves forward (feeding) if click the below one.
This action requires the nozzle temperature to reach the melt temperature of the filament.
55
Advertisement
Table of Contents
