Table of Contents
Advertisement
A. In layer setting, there are layer height and first layer height. Layer height means height for each layer
during the printing. It's generally based on nozzle diameter. The higher the value, the coarser the product.
The lower the value, the finer.
The height of the first layer will be lower than the other layers because first layer will be pressed down and if
too high, material will pile up, not good for other layer printing.
B. Then it's the perimeters. Perimeter means the minimum thickness of the outer layer, normally no less than
3.
C. Horizontal shells means layers on the top and bottom, often with solid layer. You can define the top and
bottom layer here.
D. For advanced, just use the default ones.
2). infill settings
57
Advertisement
Table of Contents
