KEYES ROSTOK Manual And Manual page 37

Please refer to below table for concrete connection position.
1.Wiring of motor and
limit switch
This printer is
equipped with four
stepper motors with
each one carries fixed
interfaces. Limit
switch on the same
slider must correspond
with motor interface,
otherwise, limit switch
or even the whole
structure may be
damaged during
debugging
Limit block: connect
interface of
Left side
HX2.54-3P with
slider in
collision board
positive
direction
Stepper motor
Limit block: connect
interface of
HX2.54-3P with
Right side
collision board
slider in
positive
direction
Stepper motor
Limit block: connect
interface of
Rear side
HX2.54-3P onto
slider in
collision board
the
positive
direction
Stepper motor
Air blower
Nozzle
Red line+
35
Color of J12 connecting line is
black and blue
3D V1.2 X motor interface
Color of J10 connecting line is
black and green
3D V1.2 Y motor
interface
Color of J8 connecting line is
black and green
3D V1.2 Z motor interface
3D V1.2 FAN