KEYES ROSTOK Manual And Manual page 104

Move 0.1mm
Move X: move the extruder along the X axis
Move Y: move the printing stage along the Y axis
Move Z: move the extruder along the Z axis
Extruder: extruder feeding/retracting
X: +000.0 ( rotate the rotary knob, move the trolley)
Control: mechanical control
 Temperature: temperature control
Nozzle: set the target temperature for the nozzle
Fan Speed: fan speed, 0 the lowest, 225 the fastest.
Autotemp: ??
Min: ??
Max: ??
Fact: ??
PID-P: P value controlled by temperature PID ( suggest not to change the value)
PID-I: I value controlled by temperature PID ( suggest not to change the value)
PID-D: D value controlled by temperature PID ( suggest not to change the value)
PID-C: ??
Preheat PLA Conf:setup for preheating PLA
Fan Speed: fan speed when preheating PLA
Nozzle: target temperature of nozzle when preheating PLA
Store memory: ??
Preheat ABS Conf: setup for preheating ABS
Fan Speed: fan speed when preheating ABS
Nozzle: target temperature of nozzle when preheating ABS
Store memory: ??
 Motion:motor control
 Accel: preset the acceleration for XY axis
Vxy-jerk: ??
Vz-jerk : ??
Ve-jerk: ??
Vmax x: maximum speed of X axis(mm/s)
Vmax y: maximum speed of Y axis(mm/s)
Vmax z: maximum speed of Z axis(mm/s)
102