WisyCom MTB40 User Manual page 9

<INFO> menu
This menu can be entered by scrolling selector.
<IRDA> menu
This menu can be entered by pushing
On power on the device, the IRDA interface is enabled for 14 seconds.
<LOCK> menu
This menu can be entered by pushing
<BOOTLOAD> menu
This menu can be entered pushing at the same time both up and down selector and then pushing the
ON button ( +
In this menu it's possible to see:
-
FW version
-
HW version
-
Serial number
-
Bandwidth
-
Bootloader version
-
Option
.
While there is this menu, the device can be connected to IRDA for
setup or firmware upgrades.
Note: if the IRDA interface is enabled and there's no communication
for around 10 seconds, the IRDA interface is automatically turned
off.
.
Long pressing (2 sec.) selector button (SEL) it locks MTB40 in
transmission mode.
To unlock, long pressing (2 sec.) selector button again.
& ON) or connecting the device via IRDA using the IR Programmer for FW update.
Device is forced in bootloader mode to allow FIRMWARE UPDATE.
MTB40 User Manual
9