Sensor & Capture Setup - iCanTek iCanView 240 User Manual

iCanView240/250 User's Guide
5.6. Sensor & Capture Setup
This is the setup page for sensors and video capture conditions. Captured video can be sent to user by FTP or E-
mail upon configuration.
Sub Field
Field/Button
/Button
Sensor 1
Sensor Setup
Video Capture
Condition
Sensor Select
Motion
Detection
Fig. 5-9 Sensor & Capture Setup
For the sensor setup use the OSD menu available from virtual
system controller. [Refer to iNVR user's guide]
Name
It sets the condition of video transmission via FTP or E-mail. The
iCanView240/250 supports 2 types of conditions which are mutually
independent.
1. Sensor initiated: when at least one of the sensor detects
alarm condition.
2. Motion-Detection initiated : when motion is detected from
video channel
Check to enable Sensor initiated capture.
Check to enable motion detection initiated capture.
Description
Not applicable for iCanView240/250.
Not applicable for iCanView240/250.
Rev.1.0 (Dec.2006) 37