Seagull Models SEA238 Assembly Manual page 7

Loctite secure.
Throttle servo arm.
INSTALLING THE RECEIVER SWITCH.
Install the switch into the precut hole in
the side, in the fuselage.
WWW.SEAGULLMODELS.COM
Adjustable servo
connector.
Servo arm.
Rudder servo arm.
Elevator servo arm.
3/32" Hole.
Trim and cut.
INSTALLING THE ENGINE SWITCH.
Trim and cut.
Switch.
INSTALLING THE STOPPER
ASSEMBLY.
1) Using a modeling knife, carefully cut
off the rear portion of one of the 3 nylon
tubes leaving 1/2" protruding from the
rear of the stopper. This will be the fuel
pick up tube.
2) Using a modeling knife, cut one length
of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and
the other end to the nylon pick up tube.
.
Switch.
7