Apply The Decals - Seagull Models SEA238 Assembly Manual

INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot,
.
seats.
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well to
the cockpit. (or you can order others scale
pilot figures made by Seagull factory.
They are available at Seagull distributors.)
If you are going to install a pilot figure,
please use a sanding bar to sand the base
of the figure so that it is flat.
3) Position the pilot figure on the cano-
py floor as shown. Use epoxy to glue the
base of the pilot figure, please see pic-
tures as shown.
10mm
WWW.SEAGULLMODELS.COM
Epoxy.
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fu-
selage using a felt-tipped pen.

APPLY THE DECALS.

1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and
aid in their location.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
INSTALLING BATTERY - RECEIVER.
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.
Epoxy.
27