Splicecom Maximiser Installation And Reference Manual page 63

Installation and Reference Manual
Viewing the IP address
To determine the IP address of a PCS 410/400, on the handset press the More Options
and then the Information
The IP address of a PCS 100 is displayed during power up of the phone. Alternatively, after power up
press the Down arrow once (or twice if Favourites are displayed) on the handset, the IP address will be
displayed on the screen. Press the down arrow or up arrow to return to the previous screen.
A list of the IP Addresses for each
PCS 410/400/100 can be viewed in
Manager by selecting Utilities and
then IP Addresses.
Setting the IP Address
When connecting a PCS 410/400/100 to the system for the first time a DHCP server is required to give the
PCS an IP address. This address can be viewed as described above. However once connected the PCS
410/400/100 can be given a static address as follows:
1 Within the Command prompt enter
telnet <ip address of PCS 410/400/100>
2 You will be prompted for a Username, enter
3 You will be prompted for the password for this IP phone. By default this is
the Setting the Password section from page 56 for further details.)
4 Wait for a # to appear to confirm a connection has been made to the PCS
setnet
5 Enter
6 The current configuration will be displayed. You will be asked if you wish to change any of this
configuration.
y
7 Enter
8 You will be asked how the IP address will be assigned.
d
9 Delete the and enter
10 Follow the onscreen prompts entering the IP address you wish to give the PCS, eg 192.168.0.50,
the netmask you wish to use, eg 255.255.255.0, the IP address of the Gateway (Default Router), eg
192.168.0.1 and the IP address of the TFTP server which will be the IP address of the Call Server to
provide software to the PCS during an upgrade, eg 192.168.0.1.
11 At any other prompt make the changes you require otherwise press Enter to leave the option
unchanged.
12 You will be asked if you wish to save the changes. Enter
13 Telnet will display that the changes are being saved.
14 When finished enter
Please note:
If a PCS 410, 400 or 100 has been given an IP address already being used on the network a warning
•
message will be displayed on the screen.
System Operation
Installation and Reference Manual v3.2/0410/6
icon.
eg telnet 192.168.0.250
s
poweroff
and the PCS will reboot
diag
y .
icon twice
7388
. (Please refer to
57